博文

Reasons and Damage of Multi - stage High Pressure Feed Water Pump idling

Multi-level high-pressure feed pump idling is a very dangerous behavior, will cause unnecessary impact, then why will the centrifugal pump empty, there will be what harm, how to deal with idling, first of all is sure that the seal will be damaged, Sealed flushing water normally open, this problem should be able to solve it?   Multi-stage high-pressure feed pump idling reasons:         1, the pump is not sufficient import media or water pressure is not enough, or pump inlet pipe blockage, or pump air inside the cavity is not exhausted;         2, the pump idling, the impeller without contact or very little contact with the media, can not work effectively, the liquid can not be properly transported out, these are doing useless work;         3, because there is no effective work, the motor load is very small, resulting in a small current, the impact of the motor will not have anything, the pump idling on the pump is real...

What is boiler feed water pump warm up

Now the performance of the pump material are good, basically no warm pump system, and improve the reliability of the device, reducing the complexity of the system, and now the domestic pump material performance are good + dynamic clearance gap, so basically no warm pump System , but because of the import of the pump to move the gap between the small high efficiency, spare pump must be warm pump, but also consider the upper and lower temperature of the pump casing in the control requirements. Upside down can be recovered quality, so there is a pump running standby pump are used to warm up. Now a lot of pumps do not have a warm pump, not because it is not imported pump, and material and structure are related to it!         Is warm and warm should not be much difference, all from the role of warm pump, the general situation, the initial start of the pump, to use the warm, as a backup pump, when there are other pumps running, to start the pump, Use upside down.  ...

Why should the boiler feed pump be equipped with hydraulic coupler?

Boiler feed pump consists of multiple parts, of which the boiler feed pump hydraulic coupler is an important part of its operation in the boiler feed pump plays an important role. Hydraulic coupler mainly by the pump wheel, turbine and rotating jacket and the composition of these parts, each part has its own role.  Boiler feed pump with hydraulic coupler reasons:     1, simplify the water supply console, improve the boiler water supply system to run the reliability.     2, the unit to participate in FM, peaking, often under low load operation, the use of hydraulic coupling speed, compared with the throttle adjustment, the pump power consumption can be significantly reduced.     3, the use of speed to the pump, the simplified water supply console and operation switching steps for the boiler to achieve full adjustment of the water supply to create a good condition.     4, to facilitate the hos...